Farley`s Dodge Diplomat Forum

Forum Index => The Library => Topic started by: Mike on December 29, 2007, 14:10:43

Title: Electrical: Electronic Ignition
Post by: Mike on December 29, 2007, 14:10:43
This is the wiring diagram for doing the electronic ignition change with a vacuum distributor. The start wire hooks upto the starter relay at the ballast resistor spot and the run wire hooks up to the blue power wire that used to go to the computer. Use a volt meter or test light to find it. Instructions for this change will be at this link:  Electronic Ignition Swap (https://www.dippy.org/upgrade/ignition.pdf)